Damper/harmonic balancer

[letterman7]

Hi guys,
As I've been tearing down and working on my '74 block, I'm wondering if there was ever a two groove harmonic pulley available for these motors? I'm stripping the motor to the bare and moving all the accessories to below the engine. I'm not running a belt driven waterpump, and the only two accessories will be an alternator and a/c. I could probably figure a way to rig a single belt to drive both of those off the one groove, but a two groove pulley would certainly be easier. Anyone know of anything that would fit off another Ford 2.8 be chance? Four bolt mount, with the center big bolt.
Thanks in advance!

Rick

 

[Hotrodlincoln]

I'm thinking for some reason the 2.8 in the Ranger and B2 has a 2 belt crank pulley. If either of mine were at home right now I'd go check.

 

[kimcrwbr1]

I have a 84 2.8 and it has the double pully on the crank it is just the matter if the shaft end and seal and key and timing marks are the same it is just pressed on with the big bolt. I would imagine they are the same though lots of 2.8 in the bone yards