clutch problems help!

[95ranger2.3l]

hey,
so my clutch on my ranger is acting up, its sometimes not fully disengaging so its not going into gear, start from a stop obviously. if i pump the pedal a few times then it goes into gear and then it will be fine?then sometimes coming to a stop,i put it in gear then when i take off i start to disengage the clutch, and theres a big rattle/grinding then when the clutch grabs in goes away?

what i've done so far is replace the clutch master, and bled it twice after.
im thinking there still is a air bubble in the system

plase any help will be appriciated

thanks

 

[ghost_rader]

is there any sign of fluid leaking out of the bell housing, you might have a bad slave.

 

[thegoat4]

The rattle is indicative of a mechanical failure of the clutch itself or the pilot bearing. Time to pull the transmission and take a look at everything.

 

[95ranger2.3l]

there is a little fluid out of the bell housing, im going to replace the slave.

 

[LearjetMinako]

If theres enough miles, you may want to consider replacing the clutch and everything else in the bellhousing.