Has anyone out there done an axle swap on a Bronco II where they swapped out the axles with those from a Full-size Bronco? If so let me know how it went. I am thinking about doing it, but I would like to know some of the troubles people have run in to.
Bronco II axle swap
- Thread starter bldthrst
- Start date
lil_Blue_Ford
Cut & Weld
TRS Forum Moderator
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
TRS 25th Anniversary
V8 Engine Swap
- Joined
- Aug 6, 2007
- Messages
- 13,062
- Points
- 3,101
- City
- Butler
- State - Country
- PA - USA
- Vehicle Year
- 2000
- Vehicle
- Ford Ranger
- Engine
- 5.0
- Transmission
- Automatic
- Total Drop
- 4”
Are you planning on going with a straight front axle or a TTB?
I think it was 4x4Junkie that did a TTB swap on a BII, he has a write-up about it on the tech pages here (link at the top of the page).
I think it was 4x4Junkie that did a TTB swap on a BII, he has a write-up about it on the tech pages here (link at the top of the page).
- Joined
- Aug 19, 2001
- Messages
- 10,967
- Points
- 5,101
- City
- So. Calif (SFV)
- Vehicle Year
- 1990
- Engine
- 2.9 V6
- Transmission
- Manual
- Tire Size
- 35x12.50R15
Yeah, mine shows it narrowed, but it's mostly the same. With it wide some coil bucket mods are needed.
Check out these posts:
http://www.therangerstation.com/forums/showthread.php?t=41341
http://www.therangerstation.com/forums/showthread.php?t=51465
Check out these posts:
http://www.therangerstation.com/forums/showthread.php?t=41341
http://www.therangerstation.com/forums/showthread.php?t=51465
Sponsored Ad
TRS Events & Gatherings
Latest posts
-
-
-
-
-
-
-
-
-
Wanted WTB: 1989 Ranger passenger side windshield wiper arm- Latest: Li'l Work Truck
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
