Bronco 2 carb help

[84bluebronco2]

Went to start up by 84 B2 this morning and it ran fine for about 30 seconds. At that point it started to idle rough and about a minute later stalled. It will run normally if you hold your foot down on the gas pedal just a little bit. I took of my air cleaner and noted there was some fuel spray up into my air cleaner and on top of the carb itself. There is a small amount of fuel dripping from the area near the idle advance. Anybody else ever have this problem?

-- 84BB2

 

[kimcrwbr1]

pull the top of the carb off and see if the float bowl is full of fuel the wet float level needs to be I believe 7/16 from the top of the float bowl to the center of the fuel in the bowl you may need a rebuild kit let us know what you find out.

 

[martin]

While you have the top off the carb, remove the float and shake it, if it has fuel inside it it's time for a new one.

 

[84bluebronco2]

If I have sometime tomorrow I will start digging. Thanks for the help so far!