• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Brake pedal vibrating at a stop


And... a few days later it's back again. Is there a way to check the signal from the controller behind the radio to the solenoid and see if it is sending a signal causing the abs to kick in incorrectly? This seems to be a relatively simple system that shouldn't be that hard to fix. Esp. Since most parts of it have been replaced.
 
I noticed today after rebuilding the back brakes with new drums. Shoes, and hardware- this only happens under 5 or so mph and the speedo bounces at the same rythym. Seems like a signal issue. The only parts left to check seems to be the wiring connector on the vss and the tone ring.
 
After all this time, I finally found the source of the problem. After noticing that there was axle fluid leaking, I tracked it to the o-ring on the vss sensor. Didn't want to dig for a workable o-ring, so ordered another VSS. Installed it and bingo. Leak stopped and vibrating pedal/bouncing speedo fixed. So either the two previous vss sensors had an issue, or something with the connector.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top