Anybody know the factory spec for ground to center of fender???

[disciplerocks]

Good to know. I'm at 24.25 front and 22.75 rear. So I guess thats 5.75" lift front and 4.25" on the rear which is weird, but she sits level.

 

[geck0]

Just measured, i'm at 22.25 rear and 21.5" front so 3.75" rear lift and 3" front, but i'm sure it'll change once i get the A4LD back in and then drive it for a bit.

 

[disciplerocks]

I measured ground to body line on front and rear and the rear is still sitting 2.25-2.5" higher than the front.

 

[The Jester Race]

I measured ground to body line on front and rear and the rear is still sitting 2.25-2.5" higher than the front.

I had the same problem, it looked level to me but it was 1.5" low in the back. Fixed that yesterday with some Belltech 6400's.
Might want to check your body mounts. That could have some to do with it.

-Jester

 

[disciplerocks]

Actually been working on those this week.

 

[BONES]

Cool, I wish I had the fender lips left intact. Anyone know how far the body line is above the fender lip?

 

[RacinNdrummin]

Good to know. I'm at 24.25 front and 22.75 rear. So I guess thats 5.75" lift front and 4.25" on the rear which is weird, but she sits level.

Remember though, the 2nd gen has more arch in the front fender opening than the 1st gen does. Im not sure what the exact difference is though...

 

[94xlt4.0]

Cool, I wish I had the fender lips left intact. Anyone know how far the body line is above the fender lip?

my gen 2 is 8 3/4 inches from the fender lip to the top of the body line in the front and 11 inches in the rear. i measuered dead center of the wheel arch to the highest point on the body line. and after reading these measurements i found out my front is sagging hard. 17 inches from center of hub to the feender with 31's