Air Intake

[Buckeye Ranger]

I really want to get a new aftermarket intake for my 95 Ranger 2.3 L. It seems that the only thing I can find is a K&N for 200 sum bucks. Do any of you have some pictures you could post to show your intake setup?

 

[Ranger44]

That's about the cheapest you're going to find it. But...in all, those don't do any good(waste of money). You are better off leaving the intake stock and dropping in a K&N replacement. The stock system flows more air than you truck can flow. The only two things I would do is remove the baffle inside the intake pipe(just pulls out) and change to a high flow replacement. My .02.

 

[Buckeye Ranger]

Where is this baffel at I heard about doing that but tried to get it out and either I was messing with the wrong part or something... Could you help me on that one bud?

 

[Ranger44]

Should be in the straight part of the intake. There is a slight lip and just pull it out, here is a link for the older models, but this may help you understand:

http://images.google.com/imgres?img...anger+air+intake+mod&svnum=10&um=1&hl=en&sa=X

 

[jokerl90]

Many thanks Ranger44 for the tip about the baffle in the intake! Made a big difference. It's hard to believe how small the hole is in that thing compared to the rest of the pipe.

 

[Ranger44]

No Problem!!!

 

[treefiddy]

I have a MAC air intake. I think I payed 140 a couple of years ago. If I were to do it over, I would have just removed the baffle/intake muffler for less money and pretty much the same effect... or I might have gone with the K&N or Volant intake because of them being plastic to help keep a lot of the heat out of the intake air.

anyways, here's mine...

 

[Dave R]

Gee, I don't know, treefiddy, I'm never against saving money but, that's a nice clean install/look.

 

[treefiddy]

Gee, I don't know, treefiddy, I'm never against saving money but, that's a nice clean install/look.

Thank you. The fit is better and the install looks cleaner over the Civic intake I had on there before.