a little different conversion

[mdduncan2155]

I have a 1987 bII that I have had for awhile. To make a long story short I had 2 BII's (both 2.9's). Now my BII is sitting in my barn with no engine or wiring harness. I have a 302 out of a carb'd crown vic, a standard tranny and transfer case from a manual f150 (around 1984) as well as axles (front and rear) from an explorer. I want to make this thing into a plow truck (no emissions worries) and I am wanting to know if I can do it relatively easily without pulling my hair out. I only have about $400 into everything and want to do it as cheap as possible. I have followed this site for awhile and I hope to be able to do this and be proud of my work. All your input would be greatly appreciated.

 

[projectnitemare]

Yeah that stuff will work fine. If you want to do it cheap you need to take your time and look for deals on the rest of the parts like a radiator, filter relocation kit and the other small odds and ends. You have the major stuff covered. Good chance the F-150 t-case isn't going to fit too well, most likely you will have a BW1356. Get a NP 205 or 208 and it will work a little better.

Matt