98-11 torsion bar suspension lowering arms

[lil_Blue_Ford]

They look very good, but 700 is just too pricey for me

Yeah, it is a big bite to swallow. I’m not raising the rear of my
Ranger though unless I can’t get the front low enough even with these. I’m determined to make this truck work at the height the rear has ended up at. Counting the time I’d have into it to fabricate these myself with limited tooling, it’s a fair price. Nobody else makes them. Literally. I don’t have the tooling or the time to make them, but I was trying to figure out a way to make it happen because I was getting desperate. Time is money and I don’t have enough of either.

 

[Lefty]

I completely agree. I know it would be a nice improvement, but I'm just not that rich.

 

[JoshT]

Yeah, it is a big bite to swallow. I’m not raising the rear of my
Ranger though unless I can’t get the front low enough even with these. I’m determined to make this truck work at the height the rear has ended up at. Counting the time I’d have into it to fabricate these myself with limited tooling, it’s a fair price. Nobody else makes them. Literally. I don’t have the tooling or the time to make them, but I was trying to figure out a way to make it happen because I was getting desperate. Time is money and I don’t have enough of either.

Now that he has them live on the site, I'll order a set in a week or three.