I just wanted to see if anyone has made one of these. Just changed out my speakers in my 86 Ranger and they're kinda free-hanging right now, only screwed in on one place. Was considering making one in Solidworks and dropping the file in case anyone would like to 3D print one, but wanted to see if something like that might be out there before going ahead.
5.5" 3-screw to 4-screw adapter
- Thread starter BoomTexan
- Start date
- Joined
- Oct 24, 2012
- Messages
- 5,591
- Points
- 1,601
- Age
- 36
- City
- Lafayette
- State - Country
- TN - USA
- Other
- 1978 Honda XL350 12v & Electronic Ignition Swapped
- Vehicle Year
- 1988
- Vehicle
- Ford Ranger
- Drive
- 4WD
- Engine
- 4.0 V6
- Transmission
- Manual
- Total Lift
- 4"
- Tire Size
- 245-70-R16
I traced the cover onto some flat plastic stock then traced inside that line by 1/2 in or so. Drilled for the 3 holes. Then used a holesaw to set the new speakers in and drilled for the mounting screws.
I could've sworn I had pictures of that. It looks like all of my pictures and e-mails between 2017 and 2021 just ceased to exist... WEIRD
I could've sworn I had pictures of that. It looks like all of my pictures and e-mails between 2017 and 2021 just ceased to exist... WEIRD
Sponsored Ad
TRS Events & Gatherings
Latest posts
-
-
-
-
95 Ranger instrument cluster backlight question.- Latest: BobSacamano
-
-
-
-
Recently Featured
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
