351w & tri-Ys?

[FlamedRanger87]

I just dropped a 351w in my '87 Ranger and have been looking for header ideas. After extensive searching I noticed a great deal of swaps with people talking about tri-Y headers but they don't say what part number they used... I was hoping if someone could point me in the right direction. I realize it will require a great deal of modding....

 

[dangerranger83]

Digging the green color.

Most swaps I've seen, you have to either make custom headers or notch the frame to get headers to fit.

Sent from my rooted SPH-D710 using Tapatalk 2

 

[Thed]

I hate you for running AFR's.

 

[v-8power]

Nice looking truck.

As far as the try-ys with a 351w, if you have a torch you can heat the primaries up and get then to hug the engine a little bit. Just need the collectors 1-2 inches towards the block for it to work. Good Luck with it.

 

[FlamedRanger87]

Thanks guys for the tips. Does anyone have a part number that might be a good start?

PS why do you hate me for the AFRs haha

The Motor

-94 lighting roller block 30 over
-AFR 185s
-XR270RF-HR comp cam
-Forged Rods & pistons(flattop 2 valve cut)
-QuickFuel 680 carb
-1.6 Comp cam rocker arms
-Comp cam roller lifters
-Edelbrock RPM Performer

Tranny is a AOD out of a 84 Thunderbird built up with stage 2 shift kit
-B&M Holeshot 2400 torque converter