2002 Ford Ranger 4.0L V6 4x4 5 Speed Manual: Cannot shift into gear regularly/periodically when engine is on. Shifting when engine is off is easy, with rare binding or getting stuck but generally easy. While engine is on, shifting up to other gears and back to first sometimes allows it to get into gear, but sometimes all fears are locked up and engine needs to be turned of and then shifted into first before restarting the engine and driving. Clutch has engagement, the rear has been jacked up and shifted into first and there was no lag when clutch is released from the floor, no suspected air in the system, but the fluid may be old. When car has been driven for a while or is warm, little to no shifting issues. What could the possible issues be and what are the solutions? New ATF mercon 5 was drained and refilled ~6k miles ago
2002 Manual Transmission Shifting Issues
- Thread starter RPM23
- Start date
The transmission locks up sometimes after shifting? If that is the case, that tells me someone has been into the transmission, and did not re-install the shifter interlock pins and springs.
What I am familiar with is the earlier 5 speeds around 1984-86. I bought my BII cheap because the 5 speed was bad and pulled out. I investigated what happened, several of the teeth were sheared off on the front two gears. After further investigation I found the shifter interlock springs and pins where not installed. This allows the transmission to be in 2 gears at once, and that locks it up. Must have happened at speed on this trans and sheared the teeth off.
What trans do you have?
What I am familiar with is the earlier 5 speeds around 1984-86. I bought my BII cheap because the 5 speed was bad and pulled out. I investigated what happened, several of the teeth were sheared off on the front two gears. After further investigation I found the shifter interlock springs and pins where not installed. This allows the transmission to be in 2 gears at once, and that locks it up. Must have happened at speed on this trans and sheared the teeth off.
What trans do you have?
- Joined
- Oct 24, 2012
- Messages
- 6,316
- Points
- 1,601
- Age
- 36
- City
- Lafayette
- State - Country
- TN - USA
- Other
- 1978 Honda XL350 12v & Electronic Ignition Swapped
- Vehicle Year
- 1988
- Vehicle
- Ford Ranger
- Drive
- 4WD
- Engine
- 4.0 V6
- Transmission
- Manual
- Total Lift
- 4"
- Tire Size
- 245-70-R16
02 4.0 Manual has to be the M5OD-R1. Maybe the M5OD-R1HD. Unless somebody swapped something else.
Was Mercon V acceptable by then? I didn't think it was.
I read that as hard to shift till it warms up. Maybe not?
If it were mine, I'd consider a fluid swap to Dexron/Mercon. Then try to find a way to check pilot bearing...
Was Mercon V acceptable by then? I didn't think it was.
I read that as hard to shift till it warms up. Maybe not?
If it were mine, I'd consider a fluid swap to Dexron/Mercon. Then try to find a way to check pilot bearing...
I have the M5OD-R1 (M5R1), the fluid was drained and filled with Mercon V around 4-5k miles ago. The truck has 204,500k miles on it. When its warm it shift ok, still somewhat a pain to get into first from stop and second is a little rough but the upper end gears are smooth
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
