Welcome Visitor! Please take a few seconds and 
- Joined
- Dec 9, 2025
- Messages
- 7
- Points
- 1
- City
- KUTTAWA
- State - Country
- KY - USA
- Other
- 1954 Chevy 3100/ K10 frame swapped
- Vehicle Year
- 1987
- Vehicle
- Ford Bronco II
- Drive
- 4WD
- Engine
- 5.0
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 33x12.50
Doing a 4.0 swap. I have two 2.9 engines, one from a 1990 and a 1988. Mostly complete. Alternator, compressor, distributor.
1988: Ran when pulled, stuck after sitting indoors for four years. Never opened up to my knowledge. No water in oil.
1990: Blown head gasket, water in oil. Heads removed, look good but haven't been fluxed. Minor rust marks on journals. Bearings not terrible. Good builder.
Will sell whole or parts. $200 each, $300 for the pair. Local pickup. PM if interested in parts.
1990 2.9 BII Engine harness. Complete from fuse box on. $75 shipped
1990 2.9 Auto ECU $75 shipped
1987 2.9 Manual ECU ----- SOLD
Will ship small parts
Kuttawa KY 42055
1988: Ran when pulled, stuck after sitting indoors for four years. Never opened up to my knowledge. No water in oil.
1990: Blown head gasket, water in oil. Heads removed, look good but haven't been fluxed. Minor rust marks on journals. Bearings not terrible. Good builder.
Will sell whole or parts. $200 each, $300 for the pair. Local pickup. PM if interested in parts.
1990 2.9 BII Engine harness. Complete from fuse box on. $75 shipped
1990 2.9 Auto ECU $75 shipped
1987 2.9 Manual ECU ----- SOLD
Will ship small parts
Kuttawa KY 42055
Last edited:
