illili
Member
- Joined
- Apr 5, 2011
- Messages
- 9
- Transmission
- Automatic
The detailed version of that picture is great! I've saved that on my compy and definitely will print it out.
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Not a foolish question, but a rather foolish answer.
Ford, instead of putting the camshaft position sensor on the camshaft, decided the oil pump was a better spot.
So if the oil pump gear is not in sync with the cam+crank, it'll throw off your ignition timing and your fuel injection timing.
Believe this is true for all 95+ at least until the Duratech came onto the scene.
When I properly aligned the oil pump gear to the diamond (when I eventually found the blasted mark under all the crud) and not the triangle it cleared my engine right up. I had a fancy scanner hooked up to it and it was kicking my ignition timing advanced 40-50°. sputters, misfires, very easy to stall in the lower rpm's, poor performance all the way around. After alignment, everything was good to go. The crank keyway was vertical on all attempts.
Took it apart and back together 3 times before I finally figured it out, put probably 4,000 miles on it running like shit because I had to.
i would think lenth is a factor. are u sure u have the correct belt. if anything the new one should be small due to the old being stretched from use. a trick i would have done if i didnt have to do my tension when i did mine is cut ur belt in half with wise and slide the new one on and then cut the rest of the old one off. it also helps alot with 2 people. one person to do the tensioner and the other to slide on the belt.
I don't know if the crank key way is at 12:00 since I didn't have to plull the crank pulley off. Do I need to pull it all apart again and use the TC mark on the plastic cover? Or is my cyl 4 miss more than likely caused by something else....??Ignore the dot on the crankshaft gear, just make sure the keyway is straight up. This will be TDC, I don't know what that dot is used for.