• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

valve cover

  1. GRNRANGR

    2.3L ('83-'97) recent head gasket blow up. foamy or milky oil.....

    recent head gasket blow out/replacement now i havefoamy or milky residue in valve cover and smoke coming from valve cover out the hose that goes back to the intake throttle body. truck running not so good. rough idle and poor acceleration, but gets up to highway speeds. help. oil changed...
  2. stamina

    anything to do after valve adjustment?

    is there anything i should make sure i do after adjusting valves and preloading lifters before i reinstall valve covers? likeshould i run it for a while then shut her off and let her cool down to adjust again? or should i run the motor to check if the noise is gone and then reinstall if it’s...
  3. stamina

    how to install valve lifters on 2.9l without tearing the whole thing apart

    how do i install brand new valve lifters on a 2.9 v6 without tearing the whole thing apart. she’s ticking like all hell. i saw a video where a guy removed the valve cover, then rocker arms, then pushrods and used a grabber type tool to pull the lifters out? is this possible on the 2.9 or could...
  4. '99 ford ranger 4.0 v6 starts and shuts off .

    Hi guys first i want to thank you for all the help that i can get i have a 1999 ranger 4.0 v6 2wheel drive with manual transmission, today i drove to my dads house 5 minute away, when it was time to go back home i start the truck put it in reverse and i was able to move it back a little than it...
  5. Sudden RPM Drop Confusion.

    Hey everyone, This is one of my first posts, but i've been lurking for a while. Just got a 94 4x4 4.0L V6 Manual with 225k. engine runs strong, however, There is a moderate leak in the passenger side valve cover. While coming out of a stop into 1st gear today, the engine suddenly lost...

Sponsored Ad


Sponsored Ad

Back
Top