• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

truss

  1. powerstrokekid

    Looking for someone to cut dxf files using my steel ohio

    Hey everyone I recently purchased dxf cut files for a Dana 44ttb truss, and I also have a 4x6’ sheet of 1/4” steel at home. I was wondering if anyone has a plasma table and would be willing to use my steel to keep cost down. You’re welcome to copy’s of the files. I’m located in new London Ohio...
  2. MAranger

    Cut and turn project

    Around new years I dove into a cut and turn d35 project. I set my goals: 4" added spring height for 6" of lift, and strategic bracing to make the beams stronger. I want to run 35's when all is said and done. I did a bunch of research and looked at alot of set ups. I decided against relocating...

Sponsored Ad


Sponsored Ad

Back
Top