Hi everyone, so I’ve had my ranger for almost four years. I’ve done a decent chunk of work and add ons. I recently upgraded my rear spring packs to the 43-871HD’s and now am installing my bilstein 5100 series shocks (though they’re meant for a RWD 4in lifted, I did the research and found the...
hey guys I'm sure someone has had this problem before you get new torsion keys for a 4x4 model and crank them 3 inches above stock and naturally it binds up your CV joints and bam need to replace the front end now I'm looking for a solution to the problem i am a welder so i could just cut the...
ok guys. this is the project. I am hoping some other torsion owners want to do the same thing so we can make this happen. I will do it without community support, but it would be nice to save a bit and have higher chance of success if there is a group effort.
I want to have a plush low ride...
Was just starting to crank my bars when i noticed that the right side adjustment bolt was much higher than my left.
does this mean the right has been adjusted more in the past in which case i may look at a new set of bars? or could it just be a shorter bolt thats on it?
Any help would be...
So I'm working at building my 07 Ranger. My question is; Can I swap my coil spring front end with a torsion bar front end from an 02 without any fab work? I'm trying to build in stages so this will allow me to put my tires, fiberglass, and bumpers on while deciding on which suspension I want to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.