neutral safety switch

Hi all! I’ve got a 99 Ranger with the 3.0 automatic trans 4x4. I’m putting a new trans in and I was going to put a new neutral safety switch in when I did. The old switch is a 12 pin connector but all of the switches available are all 11 pin. Even the exact same part number as the one I pulled...

Hey all! Searched everywhere online and couldn't find an answer, so I hopped on this forum to ask some of you wise folks. I have a very unique Ranger, 1990 single cab, 4.0 v6, automatic but was converted to a manual 5spd. The original electric shift T case was kept. Also has Dodge Dana 60 axles...

I ran the paperclip method for my 1992 Ford ranger 2.9l automatic engine and got a code of 67; which is the neutral safety switch, but I can't find it on the truck. Please help! I realized that I didn't touch the brake will doing the KOEO test either, could that be the problem?

Ok so I have no revers lights in my Bronco II - A4LD trans and 4x4. I first replaced the NSS thnking that was the issue - still no lights. Also its starting in all gear positions now. Will get to that later.... As far as the light issue goes - I Tested Purple/Orange wire in harness and have...