install

Hey so im installing AC on my 2011 2.3l and am trying to find the clutch coil connector to plug into the compressor. Does anybody know where it is located if AC was not installed originally because ive heard they came pre wired

There are subtle differences in headlight assemblies across different vehicles. Some come with dust covers, while others don’t. And beneath the cover, some have standard position, while others are off-center position. Recently, we received feedback from a 2005 Buick Century owner who said: "I...

What’s your first thought when your vehicle light can't work properly after installation? Most of us immediately assume it’s a faulty bulb, right? But what if it’s something else? Recently, we received a message from a Lasfit customer with a 1996 Ram 2500 who had just installed our T3-3157D LED...

If you’ve been keeping up with Lasfit lately, you’ve probably noticed our recent wave of upgraded products. Not only have we launched the T3 turn signal lights with enhanced decoding system, but we’ve also released the new and improved L2-T20 series, building on the L2-T20 series. One customer...

I just bought a transmission from a guy and it came from a 1996 Ford Ranger 2WD with a 4.0l. My truck is a 1994 Ford Ranger 2WD with a 4.0l will the transmission that I just bought bolt in the exact same as my current one also if anyone has any tips for removing and installing the new...

you see these on Ebay a lot a really versatile little switch with a few options for installing

Hey all, I just swapped my 03 RWD ranger for an 07 4x4 this year. Loving it. One thing I miss is having the dome light switch on the actual light. The roll switch/dimmer near the headlight switch isn't accessible by the passenger. I want to know if there is a way to use an older-style dome...

Im part way through the replacement of the synchronizer and Im doing it without the tool my question is HOW exact does it have to be, are we talking dead on balls accurate or is there a mm or two grace? I bought a replacement from a wrecker and I do not have the tool neither does anyone in my...

Hi all, I'm installing a detroit TrueTrac in my 7.5" rear with 3.73 gears... What all would I need to buy to do this? I know I need carrier bearings and races- Do I need anything else like shims? Also, what is the best source for these parts? Thanks in advance!!

Hi y'all i have a stock set up on the truck rite now and im thinking about going to a 2in'' skyjacker lift i would go 3in sus lift but i haven't found one? so might just go 2in'' and if later on I wana go bigger i can do a 1in'' body lift because 3 is the max i wana go, but i was just curious on...

Ok. So there are alot of great "how to" guides on here... but I haven't seen a complete and thorough "how to" supercharger install for the 4.0L SOHC engine (specifically for Ford Ranger/2dr Explorer/Sport Trac & B4000). So... here it goes. If you obtain a Moddbox Installation kit and any...

bought an 08 ranger ext cab. dosent have the folding jump seats. found em online for $100 is it possible to install them? i just have a storage compartment were the seats would go. any body know? or even done it?

I have what looks to be a Early 90's model set of ss borla headers. W/o egr port. I have a 1995 4.0 w/the egr. I was going to cut off the lone tube extension on the right one, front part of the borla header, and weld a nipple for the egr intake on the left header where it needs to be. I...