1993 ranger

1993 Ford Ranger has been sitting on a farm for 4+ years. I cleaned everything I could get to but when the heater is used, I can smell rancid mouse urine. How can I get into the air ducts or cowl to clean and sanitize it?

1993 2wd 2.3 ranger When I jack up the truck and move the wheels at the top and bottom back and forth. There is a clunk and small movement. It doesn’t move side to side. wheel bearings are good. ball joints seem to be fine as there wasn’t any movement when I grabbed the spindle and tried to...

Jim Oaks's excellent article helped me out a lot when I finished installing my 4" Rough Country lift and found that the stock brake lines were stretched too tight to even drive around while I waited for skyjacker lines to come in the mail. These lines are what I picked up from Autozone...

Hello everyone i just recently purchased a 1993 2WD XLT Extended Cab, 3.0L v6 automatic 91,000 miles/ 1 owner I will be using this truck as my daily driver for work. I will be driving from Texas to wherever my company needs me which could be, ohio, West Virginia, Kansas, Florida etc. I am...

I am in desperate need of a diagram that a dummy can read. I have a 1993 Ford Ranger 2door extended cab xlt 4.0l v6 5 speed manual. I have replaced the engine with a long block from Jegs and I think I have the vacuum lines corret but it does not always run good. I cant get the 900 RPM to stay...

i have got a complete 1999 4.0 ohv with harness and all accessories for my 1990 ranger and i don’t know all of the differences between the two (pre and post 1993/94) i already know a few of them such as the aluminum intake with no egr which i’ve already got from the yard, the wiring harness...

My 4wd does not work whatsoever. The only time the 4x4 orange light is illuminated is when I first start the truck and it does it’s test cycle but even then it doesn’t always light up. I replaced the shift motor and even bought a new 4x4 switch off eBay. I can’t seem to figure out what the issue is.

Question on a 8.8 rear axle. I can get a rear axle for free,all i have to do is take it out. it's in a 93 ranger 4.0 auto.trans. Stander cab , i checked the tag. if i'm reading it right it's a code 92. should be 8.8 2750 lb and 3.08 gears. gears are way to tall, if i get it it's going in my 1987...

So I have a 93 Ranger 4.0L 4x4 with a manual transmission. Problem: All of the gauges with the exception of the speedometer gauge are dead. The speedometer gauge goes crazy when you accelerate and goes to the correct speed when you let off of the gas. When it happened: I knew a guy that...

Hello everyone! I recently purchased a 1993 ranger as a hobby/project. I am not a mechanic by trade but love to work on vehicles. Been using the ranger station for months already, figured its time to register. I started a blog to follow some of my progress, but mostly so I can figure our how...

First off, this seems to be a great forum... also full of people with knowledge! (i have a 1993 ranger 4x4 3.0 5spd manual) i will start with a little background to my question. i had a rebuild on my tranny less than 5k ago. before it was replaced, the plugs on the top side of their Mazda...

I have a huge problem, i just put a new engine in my 93' ranger and it will not start. I have checked all the wiring and everything tons of times. I am getting spark but no fuel. The injector rail has fuel in it and enough pressure but the injectors are not firing. I checked the voltage on the...

Driving home from work...35mph....running smooth.....suddenly ( like someone flicked a switch) I lost power... I kept going by tapping the gas until it would sorta catch and have a bit of power for a second or 2 and then,,power loss again....I limped home... /// Upon looking into the engine...