injectors

What are these and where do they go? I was replacing my fuel injectors and when I pulled out the fuel rail, these fell into the engine bay. I didn't see where they fell from. And I can’t figure out where they go. Any help is appreciated! 2002 Ranger with the 2.3 Duratec motor for context. They...

Hi everybody! I'm trying to source new injectors for my 2002 B3000 (non-flex fuel), and I noticed Tasca was sold out on the Mazda injectors (1f2113250b) but still had stock of the Ford version (4L5Z-9F593-A). I'm assuming these are actually the same part but second guessed myself because the...

I recently bought a ford ranger has swapped motor to an 88 2.3 engine. Shade tree mechanic of mine said it has a 2.9 block. Changed the head gasket with a kit and re timed it. But still have no power behind the motor. Also still shakes when it starts. Need the vaccum diagram and wiring diagram...

So I have a 91 ranger with a 2.9l and I'm hearing ticking on the driver side of the engine. It ticks whether it's hot or cold. I opened the valve cover and ran it. All the rockers are getting plenty of oil. Any chance it's an injector. Just want to know the problem before spending money trying...

Hi guys, new heads on a 1986 2.9L Bronco 2. The new injectors on the passenger side don't seem to sit as far down as the drivers side. We unbolted and rebolted the fuel rail a few times and we can't seem to get the passenger side injectors to go down any lower with or without the fuel rail being...

Good evening, TRS. Haven't posted much here, so I apologize if I do anything wrong. What I've got: 1994 Ford Ranger 2.3L 5spd What the problem is: Fuel injectors are not firing. What I know: I have 12 volts at the hot wire(s), but the ground pulse isn't coming through. If I ground them manually...

Hello all I am a long time reader but this is my first time posting. I have an 89 Ranger XLT 2.9 5 speed which starts up fine idles fine but the truck has no low end power. I literally have to be 75% throttle when I leave a stop light just to keep up with traffic. Once I get over 4000K RPMs the...

i have an 88 ranger 2.9v6 the idle jumps around like crazy not sure what the problem is maybe injectors? when the truck gets warm it doesn't do it as much. if anyone has some input on this i would greatly appreciate it :) ive replaced the inline fuel pump, pressure regulator, TPS (Throttle...

Ok, so I'm doing 6 new injectors on my dad's 99 Ranger 4.0, I have everything all set and ready to go, I'm following the instructions on All-Data for replacing the injectors, which says to place them in the fuel rail and then put them in the manifold, I followed a tip online and put just a dab...

Hello, I need some advice from seasoned tinkerers. I cleaned my injectors like Dusty suggested on the RJM Injector web page. I soaked the injectors for two nights now and hooked up a test rig to blow them out and see how they were working in a general fashion. I used a short piece of tygon...

I found a killer deal on 6 injectors with fuel rail and regulator all for $25 on CL in my area. Would they be a worthy upgrade for my 4.0 before I slap it in my Bronco II? Where can I find more info on how much fuel they output and such? I did some Googling but haven't found quite what I'm...