ecu

Hey there, I need some help understanding/deciding on a few things. I have a 93 with the 2.3, dual spark head. Bone stock as of posting. Now I'll be the first to admit I'm in a little over my head, but what I stand to gain is worth the effort. I'm looking to get a standalone ECU going as it...

I have a 2.3 93 ranger 2wd. It has new plugs, wires, coils, fpr, and injectors. I have tested injector connections, power has 12v going to it and ground has 60 something ohms. I don’t remember the prefix. With old injectors it still ran rich, would have to drain and fill oil after 350~ miles...

Before I start, yes I know I'm doing something stupid that'll probably kill my engine, but I'm okay with that. So, I'm doing a cheap turbo build on my 2000 Ranger 3.0 Flex, and need to figure out a tuning situation. I'm using the factory EEC-V ECU in the Ranger, and have read of quite a few 3.0...

I was given a 3.0L V6 from a 99 Ranger. Included was the ECU, Engine wiring harness, and 5speed trans. (I have an under hood fuse box and wiring harness from a 98 Explorer.. Pinning appears to be close). Originally I was going to keep engine as a spare for my rebodied 2003 Ranger (has 1940 Ford...

this poor ranger... i've always wanted a little pup truck to put around in. i haven't a real need for my fullsize truck, i decided to downsize. i bought truck not running from a relative. i've gotta admit i lost a bit of respect for this man after this. said it only needed a flywheel and...

:icon_confused:Has anyone used a non-PATS ECM (i.e. 97 Taurus) with a 98-99 Ranger 3.0? I have a spare motor and 5speed that I'd like to install in an old MGB roadster I have. I've got the engine and trans mounted in the car, and now need to figure out wiring... I've got the engine wiring...

Recently purchased 96 Ranger 4x4 3.0. Previous owners had Ford dealership troubleshoot their ABS. Wheel sensors replaced and the dealer says the final problem is in the control module. It's evidently in the dash. Have consulted two printed manuals and a Fort TSO- can't find how to access and...

92 ranger supercab xlt 4.0l. ------------------ There's been a ticking/ clicking noise coming from the passenger side footwell recently and I think its the ECU computer. Happens around 60kph, throttle doesn't seem to matter. Any ideas what it is? -:icon_confused:-- Is there a relay in...

I've been getting this code at first intermittently now constant (since the swap) as soon as the O2 sensor kicks in. Even when the check engine light is on I can connect a voltmeter to the O2 sensor and it reads a fairly steady 0.8. When first started it's at about 0.05 then starts climbing...

Took out the 93 mt ecu today and put the 91 mt ecu in to match my year 4.0. It cranks but wont start.

Hi all - Got a code: "P0171 system too lean bank one" so, took truck to the Auto Skills Shop on post, (where we military types can do our own work and get access to shop tech and tools) The dudes there looked up codes and confirmed what I thought which was Oxygen sensor. Replaced Oxy sensor...

I bought a 92' Xploder XLT for $200 from a friend's dad. Ran and drove like new (till I ripped the motor out). The 4.0 is getting a gasket kit and a new head before it goes in to my 85 BII. I'm going to bolt it to my manual trans. So I've got some time before I NEED the new computer. If anyone...

ECU question (1992 Mazda B2200 Sport fuel injected) Though I have read on a few forums that people have replaced their ECU... I have not read that anyone suggests performing specific tests BEFORE installing the ECU. The reason I am concerned is that I received back an ECU that stated that the...

I recently swapped my automatic transmission in my 98' Ranger 3.0L V6 2WD to an manual transmission, and I need to find a computer for it to pass emissions. After calling Ford, I learned that my truck was 1 truck of the 5% produced that exact year with everything I have including the manual...