coil

I have an STX with 4-5 in lift with 33s and I cannot find the correct front shocks for the life of me everything I buy or research ends up being for torsion front suspension rangers. I have one that is literally snapped in half and I can’t find any suitable replacements anywhere. Please help...

Hey Folks! I been lurking for a couple months. I bought a 94 Ranger 2WD manual 2.3 just recently. It has ONLY 94k miles! It didn't run great when I bought it, but I've gotten it seemingly smoothed out quite a bit with some basic maintenance. (plugs + wires, trans oil, diff oil, O2 sensor...

Looking to lower the Green Meanie. Have the shackles flipped on the rear for now to level things up. Want to eventually do a drop beam/drop spring combo with an axle flip/frame notch. Won't have much of a budget so used parts is an option.

I replaced the head gaskets on a 91' Ranger 2.9 liter v6. I made sure to mark the distributor so it went back in the same way it came out. After I get it all back together, it wont start. I made sure all pigtails are connected etc. I found that I am getting power to the coil but no spark from...

Found this ranger at the junkyard. Looks like a splash but hard to say for sure. This is the door sticker: Does anyone know if these are the splash coils springs. The code says (E B) I googled a bunch of stuff but could find anything. Ok. Thanks...

the truck runs rough when started i pulled the wire off #6 and there was little spark. i pulled #5 and it was arching off everything. i have replaced coil wires and checked all grounds and still no luck:bawling:

Hello Im new here, my name is Matthew. Well I have bought my first 1989 Ranger 2.3l 4x4 xlt, $450 on Craigslist no motor, it originally had the distributor-less ignition (8 plug head). Well I have a 1988 Mustang 2.3, only problem is it is distributor instead of the distributor-less. I have been...

So in the tech library it talks about using welded washers to put under the coil to lift it, but im confused as to wear to put the washers. I havent taken the coil off yet but there is already a bushing there, so does the washers go above that or below it or inplace of it? Also could i go as far...

Hello, I have a '94 Ranger XLT 2WD and have thought about trying to level off the factory rake the truck came with. Currently I have this truck completely stock, 15" rims on 30x9.5 tires. I am trying to figure out what my front lift options are (Spacer, longer coil) as well as the adjustable...

So ive decided to save money and go with spacers. now im clueless as to how they install, cus i noticed a huge hole under my coil, so im not sure where they mount to. Can someone with IFS setup on a 2wd help me? i need pictures, so i can see what im doing. im only looking for about 1.5 to 2...

Hello Folks, I've got a '98 Mazda B2500 2WD and have been getting lots of squeak from the front passenger side. At first I thought it was my stabilizer bar link (it had snapped), so I put a new one on. It didn't stop the squeak. The sound only comes when the truck is bouncing back 'up' after...

I found a set of fabtech 2.5" coil springs online but it said it HAS to be used with a fabtech upper control arm. does it really HAVE to be used within the brand or can I run the springs with the stock arm? if this is true does that apply to all coil springs?

Guys I have a 97 Ranger with the 2.3... I was wondering if anyone can describe the operation of the coil packs.. I'm basically wondering.- Do both coils run all the time, or does one coil shut off during certain driving conditions? (like on the older Nissan 720 pickups).. If so, what...

Hey guys, So like everyone on here I'm looking to lift my 2wd Ranger. I eventually want to build it into a prerunner but that won't be for a long time so for now I just want something that will lift about 2" and give a stronger ride than stock but not be bouncy. I want to try and avoid the...

91 Explorer,EDIS, 4.0 distributerless. Was running fine then it dropped the center 2 cyliders at the coil pack, no spark at the coil for those 2 cylinders.Replaced the spark plugs and wires, it ran exactly the same on 4 cylinders. Replaced the coil 3 times no spark on any cylinders after coil...

Hey guys i have a 2005 2wd ranger xlt, i want to level it but i cant find a leveling kit that will fit, has anyone else leveled their 2wd? i was thinking about using the factory f250 coil spacers but im not sure if they will fit?? any advice would be great! i love the truck but that rearend is...