clutch issue

Hi i have a 1999 rwd 2.5l manual ford ranger, i have been having the issue where when i first start her up its really difficult to put her into gear, last night it took me about a minute to jam it into reverse and then a good 20 seconds to put her in first, however once i get driving for a...

I have owned a Ranger for about a year. However, I work on vehicles so most defects are understandable. I don’t know anything about clutch plates or the inner workings of a transmission. It would be a good idea to drop anything down here that might come up. My issue is with my third gear syncro...

2000, 128K. 5speed Hear a random clicking or tapping when clutch pedal depressed and tranny in gear. Neutral and clutch out, no sounds. Shifts ok, no slip. Any ideas

I was gifted a 2000 Ranger XLT 2.5L with an undetermined clutch issue; the clutch loses its pressure after 30-45 minutes of being disengaged, it is parked with a stick to keep the pedal engaged to avoid this. Apparently before I owned it, the previous owner had taken the truck to two separate...

I was gifted a 2000 Ranger XLT 2.5L with an undetermined clutch issue; the clutch loses its pressure after 30-45 minutes of being disengaged, it is parked with a stick to keep the pedal engaged to avoid this. Apparently before I owned it, the previous owner had taken the truck to two separate...

My daughter has a 1990 xlt 2.3 L with a 5-speed manual tranny (it appears to be the M50D-R1). We had a new clutch, pressure plate, slave cylinder, and throw-out bearing installed in Dec 2013, The flywheel was re-faced at this time. The truck ran well until about Mar 2014 when the clutch...

:dunno:Please. I am at my wits end with this truck. 1995 Mazda b-3000 4x4 manual 5 speed tranny, 3.0 engine. History= Last year I replaced the slave cylinder and master cylinder, and has been fine for at least 14 months. Yesterday as I was driving past a school in residential area( so I was...