Search results

It's time to change the transmission fluid and filter again. I'v only put 40K miles on it since it was changed last back in 2015. 87 Ranger, 2WD, A4LD atransmission. None of the current available fluids have the Dextron II on it anywhere as there are few transmissions like these left around that...

I'm in great dire need of a OEM LH wheel spindle for my 1987 Ford Ranger. I'm at my wits end locating one and even trying to do a informative search to know I'm doing a through search on the internet. I need to know for sure what year models the part covers and the part numbers the part goes by...

I have a 1987 Ranger with a A4LD. I've been doing a lot of engine work and got it humming great. I have noticed it sometimes downshifts hard. More so with OD. I have seen it a couple of times when slowing down at a stop light and it goes green I punch it and it will clunk or clang just the once...

I'm re-assembling my Fuel Injectors and rail. Correct me if I'm wrong, but doesn't the horse shoe shaped clip come in direct contact with the O ring and pushes it up into the rail? Also, concerning the upper intake, noticed these aluminum intakes get tarnished or oxidized. Other than buffing...

Does anyone know what is the injector voltage? For some reason I have it in my mind as 5 volts. Also, when reinstalling the injectors, do the injectors need to be attached to the rail first or placed in to the upper intake manifold? My Haynes manual is not clear on this.

I have a 1987 Ford Ranger 2.9L with 91k miles on it. It sat quite a bit this year because I was out of town a lot and didn't drive it. I removed the old gas and replaced the gas filter. I'm now going to put in injector kits. I can't get to where I can pull the connector off to see what kind of...