Recent content by Hapa1

OK Thanks for in input. I'll probably do something off the Lumber rack I'm building for over my Topper instead. I've got son rectangular aluminum 3 x 2 tubing I can build off of.

Wow didn't know they were that much. I bought my 03 Edge Extended cab came with a Swiss Topper on it paint matched to my Oxford white. I think it makes my "Loretta" look better I'm in the process of building a front and rear lumber racks out of 2 x 1 inch rectangle tubing up the sides and...

Hey all thinking about installing a Roof Rack. Has anyone installed one? I've got a 2003 Ranger Edge Extended Cab but these do not have a rain gutter to mount to. I was thinking about mounting brackets between the upper door and the just below the roof seal area with those special Rivet guns...

I got a killer deal on a set of 2014 Mustang 17 x 7 wheels and tires for $150. I've got a 2003 Ranger Edge extended cab 2 WD. Is there anyone running these on their 1998 to 2011 Rangers and did you need a spacer. Yes I looked at the Ranger wheel fitment guide but it said they'll fit but just...

Thanks Uncle Grump Yeah these 0500 heading to work through the woods has a lot of critters out there. I've hit 3 deer and ran over a dead one in the road with my Mustang GT "Stella" So no more driving her to work on early mornings Loretta Is my 2003 Ranger.

Hello All I was wondering what is the best replacement (for the Factory ones) Fog/Driving lights to install. I replaced my front bumper with an Addictive Desert Design Knock-off front bumper. I cut in a couple "windows" to mount the lights, but I want to use the factory wiring and switch...

Hey all, I have a 2003 Ranger Edge extended cab. As you know those back jump sets are pretty small. I was thinking of ditching the drivers 60% bench seat and putting in a bucket seat or a set of buckets in the front. That way I could take out the jump seats and mount the old passenger seat...

Hey Dirtman, like I told Sgtsandman It was a good analogy to use for the 15's for Function and 17's for Show. It'll be mostly a road truck, with some offroad over tones, ha. I'm building a few add-ons now for my "Loretta"

Thanks Sgtsandman That was a good analogy to use for the 15's for Function and 17's for Show. It'll be mostly a road truck, with some offroad over tones, ha. That's until I put a Dana 44in front and a Dana 60 in back

I know this has been beat before but couldn't find the thread. Ok I'm going to 4" spindle lift my 03 2WD Ranger Edge. I have a set of 17 x 8" rims but the truck cam with the stock 15 x 7" Aluminum ones My question is it better to up size my wheel to the 17 x 8's with 285/70 17's AT tires...

Thanks for the help ya'll. Really appreciate it. H-

Hey all two questions 1. I have a set of 2005 Dodge Ram 1500 Aluminum 17 x 8/9 rims with a 5 x 5.5 bolt pattern. I can get a the EcoPath 285/70/17 AT tire for around $100 each at Walmart. Trying to save some $$ The rangers have a 5 x 4.5 bolt pattern. There are adapters (not spacers)...