Hydraulic line tool.

[dezert dreaming]

Does anyone know the Hydraulic line size tool needed for the m5od mazda trans? I'm going to replace the clutch,slave etc.. on my ranger this weekend
Thanks

 

[modelageek]

Does anyone know the Hydraulic line size tool needed for the m5od mazda trans? I'm going to replace the clutch,slave etc.. on my ranger this weekend
Thanks

I just did mine and the clutch kit and the slave each came with the tool......

watch this http://www.youtube.com/watch?v=HgNTDGwcjZcs AND THIS
http://www.fordrangerforum.com/intr...eds-help-clutch-slave-cylinder.html#post42063

 

[Earl43P]

clutch pilot tool (Dorman #14503 for $4) and the

slave disconnect tool (NAPA # 3413 for $8

 

[bhawk]

If necessary, you can push that white plastic ring forward with 2 small screwdrivers enough to disconnect the quick connect fitting at the slave. Done it several times. But, thanks for posting the Dorman and Napa part numbers, because I am going to buy one for next time I have to replace a clutch master, because the Dorman clutch master cylinder does not come with that tool, it just shows a pic of it with the installation instructions.

 

[Joey Stacks]

I bought one from napa and it broke into pieces when I tried to use it so I used 2 flathead screwdrivers and it worked fine

 

[Earl43P]

You broke THIS? How; did you soak it in liquid nitrogen and smack it with a hammer?

 

[Joey Stacks]

the one they sold me looked nothing like that. Thin and crappy and yes It snapped right in half cost me 8 bucks and got a full refund
My packaging didnt have the napa logo on it either it was a different brand