Exhaust setups...whatcha got??

[trail B2]

Mine is simple and comes out of in front of the right rear one cat and small muffler the important thing is nothing hangs down.I'm going to put in sliders this winter and man I like Hahnsb2 exhaust hmmm.

 

[Andres629]

Uhhhh... manifold > y-pipe > cat > air

 

[Shran]

My B2 has the stock y-pipe, then a reducer I made that goes into a single pipe, then just a glass pack. It exits near the stock location, except I cut it off right by the bumper so instead of going out the side, it just goes straight back. Not really legal but it's what I had... stock cat and stuff was all rusted to shit.

 

[lethal-threat-b288]

how about just dump it!!! i have stock cat (hollowed out) and a $70 flowmaster knockoff from ebay. loud and deep. plus no rub issues or worrying about crushing a tailpipe

 

[--weezl--]

little different of a truck, but my 07 has the stock exhaust (with high flow cats i'm told) and a magnaflow muffler in place of the stock... it's going to have the tail pipe chopped off at the last hanger when i can get a sawzall to it... it looks funny hanging 5 inches below the box after the BL

 

[7111127]

i doing no cats trush muffler 1 in dual out and 2 chorme tips

 

[WoodyB2]

I got an aero turbine 30/30...no cat...almost the same as hahns but i didnt cut my body...ill prolly cut it when i get around to doing sliders...

also sound vid..not the best but hey.

 

[shawn.m]

stock y- pipe, after market cat, flow master, 2.25 mandrel bend dump to rear tire. nice and quiet with some bark. probably going all the way back rear soon.

 

[gaz]

Exhaust suggestion

JBA headers, stock "H" pipe, hi-flow 2 in/2 out cat, dual 2" to the muffler, Borla XR1 dual 2" in, single 2.5" out, then 2.5" to the tip, the tip is 3" and incorporates an exhaust control valve (it is supposed to maximise torque at any given engine RPM).

 

[B2 Addict]

This is the only way to go.

Awesome, I like this setup & I am definitely going to use it....

Do you have any pics from underneath to show exactly how it is set up?


B2

 

[Hahnsb2]

Awesome, I like this setup & I am definitely going to use it....

Do you have any pics from underneath to show exactly how it is set up?


B2

Don't have any good pics underneath right now, but this may help. It's basically 90* up and 90* over. You'll have to remove a little sheet metal lip that hangs down from the body above the frame.

 

[B2 Addict]

Don't have any good pics underneath right now, but this may help. It's basically 90* up and 90* over. You'll have to remove a little sheet metal lip that hangs down from the body above the frame.

Awesome Bro! That shows me exactly what I needed to know.... What size pipe are you running?


B2