Chirping in the rear

[rusty ol ranger]

Where would the u joint be located?

Both ends of the driveshaft

 

[Robert Mangrum]

Both ends of the driveshaft

Do one at a time if they don't have grease fittings. If they do just grease them both. If not I'd get some spray grease like lithium and spray 1 at a time to try and figure which one is bad.

 

[newnthused]

These days we all use YouTube. Here you go:

This is immensely helpful. Thank you

 

[Lefty]

This is immensely helpful. Thank you

Keep us posted

 

[newnthused]

Keep us posted

No grease fittings

 

[rusty ol ranger]

No grease fittings

They are more then likely original then....and id bet the source of your noise

 

[newnthused]

I ordered some u joints off rock auto. One for transmission site and one for rear axle. Will update within a couple weeks. Does anyone know if there's anything else I will need? I'll buy grease since I purchased Grease fitted u joints. I was just going to use a socket and hammer to remove/replace u joints.

 

[alwaysFlOoReD]

Socket and hammer is what I used for decades.

 

[newnthused]

[, post: 2030968, member: 117784"]
Keep us posted
[/QUOTE]
I fixed it! No more chirp chirp chirp! I had to rent a u joint press and get a u joint from AutoZone/return the rock auto one. But we're fixed up

 

[Lefty]

Very good!