I want to put spacers on my ranger and I know I can do it on the back axle but the front with the manual locking hubs I wasn't sure about I don't know if there's a company out there that made them big enough to put over the hubs or not, just wanted some insight.
Hey there so my front drivers side hub has been damaged on my '95 stx 5spd (manual locking hub), and Ive been searching for a while to find a replacement in my area with no luck. I was just wondering since I know its a rare part if theres anyway to get this fixed as I hate walking out the door...
I have a 92 Ford Ranger with a FM146 Tranny. I am hearing this rattling noise when hit the gas. I barely hear it in 1st and 2nd gear. I hear it a little more in 3rd and then the noise gets louder and worse in 4th and 5th gear. It sounds like a rattling/ bearing not properly lubed right or...
CONVERTING AUTOMATIC HUBS TO MANUAL HUBS ON A 1993 FORD RANGER
By: Ollie Octopus
For some time I was convinced I had shift motor, transfer case, or control module problems, when it was a *&%#&@* automatic hub problem all the time. Thanks to super mechanic Robert Cline for pointing me in the...
Hi, Looking for some help. I want to replace the vacuum hubs with the manual hubs and Rugged Ridge / AVM are the only product I've heard of that purports to fit my Ranger. However I'm having a hard time confirming "spline" count. My mechanic says my old system has a 42 spline count so I need a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.