i think im going to have to replace my timing chain and gears and after thumbing through the chilton manual it says i need to remove the oil pan. is there any way to remover the oil pan without lifting the motor or can it be done with the pan on? i do have new motor mounts to put in some day but...
im rebuilding the motor on my ranger and im lifted 4 inches on 31s and im thinking about going to 33s in a few years. should i replace the stock clutch with a good quality stock replacement or should i step up to a "stage two" clutch or will i be ok with a stock. if you have any opinions about...
In the tech library they sugest using a MSD 8227 coil t oboost performance
http://www.summitracing.com/parts/MSD-8227/?image=large
i have also seen the MSD street fire 5527
http://www.summitracing.com/parts/MSD-5527/?image=large
can anybody tell me the difference between the two, all i see is...
I have a D28 and dont have the money to upgrade to the 35. i broke the yoke on the inner passenger side axle shaft and need to replace it. i would prefer to only have it all apart once, this isn't the first time i have broken a shaft but it is the first time for that shaft. i wouldn't doubt more...
I have heard some talk of a new bronco and i have seen the concept from a few years ago but i haven't seen anything of notoriety.
just wondering what you know, links would be appreciated.
i think this might be the wrong forum but i couldn't find one that seemed to fit so i made an anounce ment. "if it don't fit Make it fit"
I would like to do a one inch body lift on my 89 bronco II. i havent been able tto find a kit so i was wondering if anybody has ever done this and how?
i was wondering if it would hurt the engine in any way to put a K&N can filter on the throttle body as described in the tech library? is it hard on the engine, will it reduce engine life? does it cause the tuning to be less than optimal? are there any side effects what so ever?
i have recently experienced some power loss in my 89 bronco II. i seem to lose power on low rpm hi torque situations suchas when the torque converter locks up. this phenominan is completely void when the rps go over 2000. is seems like it is burbling like under water or something. i assure you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.