Search results

Hello, looking for a full set of cleanish red rear seats for a Bronco II. Shipped or pick up within ~400 miles of 84780, St. George UT. No seat belts or trim needed. If this is up, I'm still looking. Thanks!

-- Located in St. George, UT -- Waag brush guard from my Bronco II. I suspect that it may originally be from a jeep cherokee but it fits the shape of fords perfectly. The extra headlight protection is removable. I'm including the mounting "hardware" that I've been using for years. I'm no...

Long story short, I reinstalled my alternator and I didn't realize that the power wire was in contact with a bolt on the back of the alternator itself. A few miles down the road the truck bucked and then the voltage dropped to around 8-9 volts and the battery light came on. I drove up the road...

2300+ Mile Trip in a Bronco II +2000 More Howdy ya'll. I just wanted to share a few pictures from a trip I just finished in my little Bronco II. First things first though; 90' Bronco II with a 91' 4.0l (with 200 miles on a top to bottom rebuild at the start of the trip), M5OD, explorer rear...

Can anyone tell me if a 93/94 water pump pulley on a 1991 explorer engine will work? I'm fed up with trying to get the fan and clutch off of my old water pump and I'm willing to replace them both but I can't find a replacement pulley anywhere. The Dorman pulley for the 94's is in stock...

This has been a quirk that I've grown accustomed to over the years but has gotten worse and is now a real annoyance. It's a multi-step routine... 1. Start & drive my 1990 Bronco II 2. Drives fine 3. Without provocation, Rear ABS light illuminates/turn signals become inoperative/battery stops...

I'm looking to upgrade my typical sagging rear springs on my 90' BII. The truck has been promoted from DD to road trip/camping rig. That means dragging a tear drop trailer that weighs 1000 pounds empty, maybe 100 pounds tongue weight and a hatch full of 100-200 pounds of gear. 95% highway...

I'm finishing up a 4.0 swap on my B2 and it's all down to wiring. This ground cable has me stumped, though. I can't get terminal 3 to reach the ground stud on the starter when the cable is bolted to the frame below the airbox. Now I'm questioning if the terminal goes there at all. Can anyone...

I've researched a few websites / threads on the problem but none of them give an solid answer. I've seen the same problems and symptoms, but no solutions. Here's what's happening, when I try to start my 2.9 cold, on mornings when the temp is roughly 45 degrees or below, the truck won't start...

Hey, I'm Andrew from Las Vegas. I have a 2wd '90 Bronco II with the rickety old 2.9. I just bought a '91 Explorer with a bad trans for the complete 4.0L swap for the Bronco II. I'm not mud-slinging, desert-bombing off road fanatic, a slow drive through the trails is fine for me, haha. I'm...