Hello everyone.
I can now say I have a v8 ranger, this has been very fun swap. I had a 92 shortbox reg cab 2.3l manual trans ranger that is now a little happier.
I took it out on a first test drive last week with my kids up and down
my gravel road. I am very happy with the way it runs and...
Ok, I have a 92 ranger 2wd, I have the EFI 5.0 in place and
almost ready to start, the doner engine is from a 91 Grand Marq.
I used the stock Exhaust manifolds and the steering shaft hits the
manifold at the lower joint in the shaft. What have other shafts have a
low profile u-joint at the...
hey,
Anyone out remember the part #'s for the radiator hoses they used
with the 4.0l extra cooling package radiator tucked under radiator
suport ?
I decided to use the the above radiator with my v8 conversion
just thought I might try to take some of the guess work out
of it.
Thanks,
Andrew.
I have a 92 2wd ranger that is soon getting a 5.0l EFI
I would like to keep my belt driven fan and tuck radiator under support.
What motor mount setup works the best to acheive this.
I would like engine to be as low and far back as possible due to the
M50D R2 trans with the larger 163 tooth...
Hello, I have recently started a v8 Ranger swap, I have a 302 EFI that is
now ready for install in my 92 2wd ranger. I have been trying to
decide on a manual trans for my Ranger, I like the format of the
M5od R2 (f-150 2wd five speed). My pickup was orginaly a 2wd 2.3L
manual. So the M5od...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.