Search results

Has anyone put a 285/75/16 on a 2010-2011 Supercab...stock... factory... does have Rancho shocks....?

Finally gonna get the VOCTech center to paint the '88......was thinking about Dark Maroon 2011 Fusion color....semi-gloss......Show me some paint schemes

and got to this site....http://www.rangerpowersports.com/forum/showthread.php/218815-Lowering-on-a-budget! Everything you want to know about lowering.

Look in the tech= info section at the to of the page. For the basics.

Saw an ad for Torque Thrust wheels today....15x8 rears and 15x4.5 fronts....what's the classes opinions of the 4.5 fronts on my '88 4x2....

Cut the front coils, and do a rear axle flip...add new shocks and your done

that's all true, it does ride smoother, it is level....but the flying concrete is not good

OKay, '88 regular cab 2wd V6 longbed and I've got American Racing Wheels with dinky tires....thinkin' about going to 15" with wide whites...what are the issues with increasing wheel and tire size?

Not worried about the mileage....but now the other issue DOES raise cause for concern.

How about 8-16" concrete stepping stones...forn and rear are now 2 1/2 inches above the tires, the ride is better and no more spinning tires on wet pavement.:icon_twisted: http://www.therangerstation.com/forums/picture.php?albumid=2653&pictureid=10470

Has anybody used this stuff?

So I installed buckets with power lumbar and side bolsters in my '88 and I was wondering if I can wire them to the sealt belt alarm wire that was hooked up to the old bench seat. The fuse panel has a block for the power lumbar but I don't know where the connector is.

Thanks doorgunner, I just read it. Really just want to make it level but might have to do a 2" front, 3" rear....man love your truck.

Just a little lower I want to do a modest...1"-2" lowered front and enough in the rear to make it level on my '88 regular cab long bed...and cheap of course...any suggestions?

Sometime in the fall I'm gonna get the '88 repainted...right now it's faded silver and Rust Bullet silver.......thinking either black (rat rod) or maroon and gray two tone but I don't want it real shiny or real dull....any suggestions?

So I got a center console out of a 90 something Splash supercab and of course the floorboard in my 88 Regular cab is different. Anybody mounted one in theirs...I could use some tips as the bottom of the console sets about 1 1/2 inchs oabove the floor booard in the back.

So I scored a set of buckets with Lumbar supports for my '88 Reg. Cab...any suggestions for wiring them?

Well, after searching every concievable spot for the water leaking on my passenger floor board I found the culprit. I ground out all the sealer that I put in last fall when I thought I found the problem and there it was....the entire drip rail had a 1/8" gap between the joints. Not being a...

I've got the standard flag mirrors on my '88 and want to change them for something other than the West Coast mirrors. Has anybody swapped for something that will screww in the same holes?

Okay so this might not be the right place but....'88 2wd Regular cab with an automatic...has anybody swapped the "T" handle with a pistol grip?