Search results

What is the fuel tank capacity for a 1987 Range long wheel base two wheel drive?

What is the fuel tank capacity for a 1987 Ranger fuel injected long wheel base?

After checking everything else to solve my starting problems ( it would start right away if cold and after attaining normal operating temperature) I decided to replace the TPI (Throttle Position Indicator). After doing so it now starts and runs very smooth with good acceleration. The TPI is...

Since the fuel pump initially provides 35 psi then drops to about 10, could a fuel pressure regulator not holding pressure cause a cold engine to start OK but then later afterwards on a restart cause difficulty unless the Accelerator is pushed to the floor whereas the pump pressure is reapplied...

My 2.9 starts right up when cold or hot but sometimes when the engine hasn't attained operating temp the starter will kick out. If I push the accelerator to the floor it will catch. The engine runs smooth, good acceleration etc.. I'm suspecting either the TPI or Engine Coolant Sensor. What think...

I may have misled folks when I posted having starting problems. Several replies referenced the starter. Actually the engine starts and runs fine when it has been setting for a spell or at fully operating temperature. It isn't a fuel problem - runs smooth, accelerates good and gets good mileage...

Still having some problems with occasional starting. It's not fuel pressure bleed down as it can sit for days and will fire right up - run smooth with good acceleration. Occasionally after being driven when attempting a restart it will seem to try but the Bendix will kick out before it runs and...

My 87 Ranger has recently had an erratic starting problem. It sometimes takes a couple of tries before it starts. Once it starts it runs smooth, accelerates good and shows no other problems. I am guessing it may be the fuel pressure regulator leaking back and not keeping fuel available until...

The other day my charging light started flickering. Usually starts after the engine warms up. Light goes out above 1500 RPM. I took it to Auto Zone where I had recently purchased a new battery and the battery checked O. The clerk suggested I check the plug ins on the alternator. Cleaned them and...

Recently when my 2.9 wouldn't start I thought the fuel pump had failed. During trouble shooting I discovered the fuel pump relay (the original '87) was full of corrosion. I cleaned all of the contacts and replaced the relay and found that it also solved some other problems often posted on the...

My '87 2.9 has been running like a dream until today and it wouldn't start. I couldn't hear the fuel pump come on so checked the fuel at the shrader fitting - no fuel. I then checked the inertia switch - it had not tripped nor has there been any reason for it to. Next step was to check the fuel...

What is the difference in the 2 wheel drive and 4 wheel drive speedometer cable? I have a 4LD tranny. Some parts stores only list the 4wheel dr. I also noted some cables 70" and other s 80". My speedometer seems to be accurate on MPH but the needle started fluxuating and I can detect a slight...

I had previously posted this on "Need Urgent Help" and had a couple of replies which didn't help. They only commented that it's a pain in the ass to do. I have found some printed instructions that includes the removal of the [U]right wiper arm,[U] then the nut holding the shaft through the cowl...

I have been having trouble with my wipers returning to park when shut off. I replaced the wiper/washer switch which didn't solve the problem. I have purchased a new motor but find with my big hands it's almost impossible to reach in behind the plate opening to remove the clip on the motor...

Is the clock light bulb in the radio in a 1987 Ranger?

The wipers on my 1987 XLT sometimes hang up in the delay mode and often don't completely return to the OFF position until I switch them back on and turn the switch off as they hit the retract spot. Any Ideas? Is there a delay relay or is it integeral to the wiper switch?

Well, I got the door lock rod clip solved - now I have a problem with my turn signal switch. It's been working fine for 27 years but today it won't lock in position or move down for a left turn. I'm guessing I will have to replace the switch but so far can't get the shroud off. Haynes...

Yesterday I pulled up on the door unlock knob on the right (passenger side) door lock and the entire rod came out. I removed the panel today and found that the plastic clip that connects the rod to the lock was broken. It's an 87 Ranger XLT. Anyone know where to purchase the necessary parts to...

I have a small leak where the cooler lines connect to the transmission. If I buy new fittings, can they be installed on the old lines? I have a 4LD tranny. I guess no one knows the answer since there have been no replies. I'll figure it out myself. Freedom5

I've been having transmission fluid dripping on the garage floor for some time now. It isn't very much and I only have to add fluid every three months or so. It looks like it may be coming from where the lines connect to the tranny. Does anyone have any good advice. First I will try to tighten...