I have an 87 Bronco 2 EFI 2.9. I have the mazda 5 speed and the BW1350 E T case and I dont have 4WD operation. I put on manual hubs to eliminate that problem, but still the front driveshaft wont spin. The motor works, so I took that off and put a 3/8 open end on it and tried to put it by hand...
I am getting a 90 bronco. Its an automatic but its pretty much shot. What manual kit or trans should I get? Which one would be the best for the swap? I looked at the origional 5 speed. Is that the only
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.