• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Search results

  1. Another d. a . question.

    Will a 3.0 bellhousing from a '91 or '92 ranger with the better 5 speed bolt up to the old weak 5 speed in an '87 ranger 2.9 5 speed? Or what would it take to put a manual transfer case from the '87 behind the 5 spd from the 3.0?

  2. 2.9 flywheel, starter and clutch on a 4.0

    I understand it may not be an advisable move, but since it is possible to bolt in a set of these from a 4.0 onto a 2.9, is it possible to go the other way and use my 2.9 components when swapping in a 4.0? The smaller clutch may have a shorter life span than the larger one, but it may also reduce...

  3. 2.3 4 cyl/ 2.9 v6 swap

    Are they the same bellhousing bolt pattern?

  4. Ranger 2x to 4x conversion

    I have an 87 ranger 4x4 , and a 91 ranger 2x4. is it possible to put the ttb axle under the twin I beam frame? Is it a bolt in, or are the frames too different? Should I convert the 91, or swap the cab and engine to the 87? any advice would be appreciated.

Sponsored Ad


Sponsored Ad

Top