Search results

I recently replaced the gear box on my 84 Bronco II because the shaft was leaking like crazy. Got everything back in, added fluid but the next day i noticed it still had a small drip. Took a closer look and it looks like the bigger line is leaking. Should there have been a gasket?? I didn't...

Ok so I bought an 88 BII a while back with the intentions of doing a 4.0 swap. The more I've gotten into it the more I've decided to do to it. Since this is going to be a long term project I bought a 99 F150 4x4 reg cab/bed with the 4.2L OHV motor. The truck runs good and the driveline is...

Ok so I have everything out of my 88 BII and 92 Explorer... I already have the EVTM for the BII... Explorer EVTM is on its way (that reminds me i should probably pick up a Chiltons too)... I am planning on putting in a set of Autometer gauges with a custom dash piece but that got me thinking...

So I tore down the 92 Explorer that I am going to use for my swap and I found that it had a Ford Vehicle Security "system" in it. Did they all have this? Will I need to plug it back in or is there a way for me to leave it out?

A while back I bought an 88 BII with a bad 2.9 and a wrecked Exploder with a good 4.0... I have finally started working on it... now I've ran across an 85 FSB that I'm strongly considering... Body is in good shape... it's 4x4 with manual locking hubs... has an EFI 302... The interior is rough...

So, I currently have a 1989 Bronco II 4x4 Auto.. I just picked up a 92 Explorer 2WD Auto... I am pretty clear on what needs to be done to move the 4.0L over but what about the transmission. They are both A4LDs but it's my understanding that I'm better off using the Explorer tranny with the...

I have been troubleshooting a problem with my 89 BII. It's a 2.9L auto 4WD... the vehicle drives fine from 0-45mph which is where i do most of my driving... however when i get over 45mph, really about 47mph i have noticed that the vehicle shakes when it drops into overdrive... if i let up on the...

Hey guys... so I recently acquired an 86 F150 XLT FI302 2WD Auto... Originally I was going to restore the truck but the more I thought about it I have decided to make 1 project out of 2. Rather than rebuild my 2.9L and tranny I might as well rebuild the 302 and swap it into my BII. The only...

Hello everyone. New guy here. So I have a 1989 Bronco II 2.9L Auto 4WD that has an exhaust leak. Looking under there things are pretty rusted. I decided that anything I replace is going to get upgraded so I am now on the hunt for some headers. Pacesetter makes a header 70-1118 that says it...