So I did some searching and havent found anything on the forum about the reason my AWD system isn't working in my swap. I used a 98 Mountainer with every piece of the drivertrain and swap it into my 99 4X4 lifted ranger. The thing is a beast but in 2 inches of snow it gets its ass kicked and I...
Ok it's been awhile since I have started a thread but I am taking on a new project. I built a 300 hp 2.3l Turbo 97 Ranger with a DP head. It's fast but it doesn't hook and I even put a full posi Explorer rear end. I am going to sell it and buy a 98 or newer Ranger 4x4 and I am going to take a...
Just picked up an 88 Merkur XR4Ti with LA3 already installed and a few other aftermarket parts. I am about to start the swap today. I only have a couple of questions.
1. Will I have to do any pinouts due to the fact I am useing the xr4ti's wire harness, computer, motor and trans. If so...
Hey everyone I just started my first turbo 2.3 project. I have a few questions and I hope someone can help me so I can get this thing rockin. I am going to start with what I have. I have a 96 Ford Ranger 2.3l, 5 speed, 2wd short bed. I have already installed a boost gauge, Air/Fuel Ratio...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.