Thank you erichphoto for your response. Yes, it runs and drives fine. I just have a check engine light and AutoZone tells me it's the cam sensor. However, the cam sensor does have an ohm reading about 600 between the 2 terminals in the sensor plug.
Thank you for your reply RonD. It's good to...
Hello,
I did a 3.0 swap from an unknown vehicle. I think it was an older ranger. Does it matter that I used my 1999 cam sensor shaft in the probably older motor? I'm getting cmp codes. The shaft seems okay but is there a difference between years that match the engine rather than the wiring? How...
Hi,
I have had too many problems over the years that end up being PATS.
I recently did a 3.0 swap to an older long block 3.0 and now it won't start probably due to anti theft being engaged.
I want to eliminate or defeat the PATS system. Can it be done and how?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.