took alternator to kragen and it tested fine. all it does is click. battery has 12.8v. the connections look good. i have no idea what to do and need my truck for work tommorow. please help
2000 Ford Ranger
2.5 4 cylinder
automatic
2wd
about a week back i noticed that my check engine light was on. unfortunately i was out of town and didnt have access to a code reader. the truck seems to run fine. its a 2000 ranger with the 2.5/auto. it only had one code. P0401 and no pending codes. i got the same code once when i had...
i found someone parting out a 87 bronco II 4x4. he has the rear sway bar and links and all the brackets. will it fit on my 2000 reg cab short bed? mines just a 2wd and the base level xl
2000 Ford Ranger
2.5/auto
reg cab short bed
it was a former service truck. there is no xl or xlt under the ranger emblem on the fenders. im pretty sure its as entry level as you can get. so im sure its the xl.
now do i have 2 or 4 wheel abs? or how can i find out? and do i have the 9 or...
first off, my sub is a elemental designs 9kv.2(8"sub). nearly identical to the e3.8 which replaced it. specs can be found on their website.
the pink line is the plot line for how my sub is setup now. its in a sealed box, aproximately .42 cubic feet.
the green line is the plot line, if i...
i just got back from pep boys. they did a a/c performance check. i was told the compressor is loud and the bearing is shot. which i agree. i was also told that the drier/acumulator would need to be swapped out once the system is opened. ok, thats fine. they said the system holds pressure...
a while ago i noticed that the boot covering the pivot joint on the lower steering shaft was torn. so i started to look for a new one. last week i came across someone parting out a 99 ranger. so i picked up the steering shaft for $25. i also have a clicking sensation coming through the...
will i be giving up ride quality going with the reflex series? i can get the reflex shocks and struts a little cheaper. this is going on my daily driver. 100% on road driving. just looking for a replacement that will give me better overall performance. let me know if you have any first hand...
ok im looking at getting a set of monroe dynamics dx652 brake pads. they come with all the hardware except the caliper guide. is that really needed?
these are what it doesnt come with
first i would like to know the fuel tank capacity is? its just the base model xl, with the 2.5/auto, reg cab, short bed
is there any way to test the mass air flow sensor and the o2 sensor with a dmm or ohm meter?
my engine seems to shake a little at lower rpms. it settles down once the rpms...
i was looking at my brakes today and i noticed that the rubber boot at the end of the steering shaft was torn. its letting moisture get in. when i hosed down my engine bay after spilling antifreeze all over i noticed a clicking/tapping vibration coming through the steering wheel. but it was...
i thought my problem was spark plugs that were gapped improperly(by me). they were gapped at .040. i opened them up to .044(which is what the OE motorcraft plugs are gapped to). that seemed to smooth out the idle a little and help with the gas mileage. after seeing those results and still...
just yesterday i started to notice a tapping sensation coming through the steering wheel. with the stereo off and the windows down, i cannot hear it. there doesnt appear to be anything rubbing on the steering shaft. any suggestion on what this could be? thanks
OBD emission readiness
i was at harbor freight and decided to pickup a code reader. i didnt have any dtc's but my emission status wasnt ready. it said:
CAT
Not Ready
EVAP
Not Ready
i want to know what could cause these monitors not to be ready and how i can fix them. thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.