-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Recent content by Old Tom
-
Ball joints
Suggest this: ( control arms with installed ball joints are available, check RA ) also, spend a bit more for brand name joints with grease fittings- Old Tom
- Post #18
- Forum: 2WD Suspensions & Frames
-
Stiff clutch and can't shift into gear
update- bleeding procedure at slave painfully slow, however was able to get 3 reservoirs full of dot3 through system. The removed fluid from system separated into: clean-top layer, dark-middle layer, and very dirty-bottom layer which contained 1/4-1/2 teaspoon of water. So far clutch has...- Old Tom
- Post #9
- Forum: Transmissions
-
Stiff clutch and can't shift into gear
I am having a similar issue with '97 Ranger rwd particularly when vehicle not warmed up. Symptom#1)Press clutch, pedal locks approx half way down. When pedal released-can feel very little pressure against foot. Usually can feel pedal pressure against foot. Then Take foot off of clutch...- Old Tom
- Post #8
- Forum: Transmissions