Just a quickie... when should I see 12V at MAF pins A to B? (B+ and ground) KOEO or KOER? That could be a big part of my problem, no voltage to heat the wire, therefore bad signal to PCM.
Hey everybody!
I just found this site tonight and must say I'm very impressed. I've been on 'another site' for a while trying to get a situation resolved but can't seem to get my point across to them or find information that I need, specifically a testing procedure for the MAF sensor. Thank...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.