My truck idles fine but shortly after putting it in gear it will die like the fuel cuts out, but if I give it gas very slow and smooth sometimes I can get it up to speed, but If I step on the pedal hard while the truck is in gear it just dies. This problem is worse when I turn the wheel also...
i have chevy 63s in the rear, and they are very soft, but my front end still does not flex as much as i like, so i was wondering what affect stiffening the rear springs would have on overall flex? would stiffening the rear just be worse for overall flex, or might it force the front springs to...
I'm looking for the best combo for the purpose of rock crawling and fitting a doubler. Right now I could get a free zf5 and the mated new process tcase, but I'm not sure If I want the zf5 or an automatic or some better transmission. Has anyone else done this before? Do you guys know of any good...
just trying to get some opinions. I run 37s woth 5.13 gears, and do a decent amount of crawling, I burned my hays super truck up after about two years of moderate to heavy driving. To replace it I just bought a centerforce stage II ,which I have read is basically the same clutch, with same...
ive got a 79 f 150 Dana 44 front and and I'm trying to do the tierod flip. Does anyone know the best way to do this or how to find the right TREs to use or a good place to buy the inserts that just require a 3/4 drill bitand not an expensive reamer. Thanks
my hazard lights work but my turn signals dont, and when the hazards are on they work intermittently and the front passenger turn signal never flashes at all. also only the driver arrow on the dash blinks.
so far i have replaced the bulbs, and flasher relays for the hazards and turn signals, i...
i use wildhorses 5.5 lift progressive rate coils with an extended radius arm ballistic joint setup and heres how well it does.
personally im looking for more flex its embarassing when im getting beat by stock width jeep yj
what do you guys use ?
anyone use jeffs bronco graveyard superflex...
is there anything i shold know before attempting this task? this would be my first time, im somewhat mechanicaly experienced but i want to make sure i have everything i need and im not getting in over my head.
thanks, josh
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.