Recent content by jarfly

have a 2001 2wd 2.3 16v, I shut the truck off and went to start back and no crank. Put new starter on and still no crank. I have checked all fuses (there good) can cross the starter over and truck will crank but nothing when I turn key. Allso bypassing the safety switch ( pink & white/pink...

I have a 03 5sp 2.3 that is missing at 2000-2500rpm after a few moments it will run like it should, not sure where to start at on this, Does the 03 2.3 have the camshaft synchronizer like the 3.0 & 4.0?

Looking to convert a 92 lbw truck to short bed. Does anyone know where the extra length is in the backhalfs?

Got a 89 ranger 2.9/ aiu to that is loosening power after it gets warmed up, you have to keep it full throttle to run 55, and wont rev past 3k I can shut truck off and let set for a bit, it starts easy and will rev past 3K. then will loose power after 10-15 minints of driving. Allso after...

Anyone here into couriers? Have been trying to find some info on a 1975 I may be getting. I am buying the truck as a roller, planes are to use a 2.3 from a ranger but not finding much info on the swap.. Thanks in advance for help.

Was thinking s10 for price wise, most likely I can get a frame for next to nothing, but a yota newer ranger should not be to hard, With doing any of these how does it affect the track width vs the stock ranger?

Looking in to doing air ride build on a i beam truck, Since I beams seem to be the worst thing in mini trucking I'm thinking of doing a clip/frame swap. I am looking at using a s10 clip and square tube. With useing a s10 clip do I have to narrow or widen the s10 stuff?

So, I have a 94 4.0 truck as a doner, truck that is getting fixed is setup for a 01 ish 3.0. Is there any way to use the newer model dash/gauges or am I going to have to go aftermarket with all the gauges? Allso, Has anyone ever thinned a 94s harness down to just what it needs to run?

does anyone know if ranger backs are the same, backhalf is from 1st gen, truck is a 97.

How long are you guys makeing radius arms? I know 12" 15" more, I can not find the lenght of the whole arm. Thanks for the help in advance.

Looking to some input, I have a 00 ranger with a bag rear diff, stock axle 8.8, I allso have a 7.5. trying to make to work on this since, I have the parts on hand. Only problem I have ran in to is ,back drive line flange & pinion plan will not mate, the 7.5s is a 1/2 shorter center to center on...

Got a friend bought a truck wih out the key, its a 2001 if I where to change the key switch would I still need reprogrammed?

Looking for some pics of spaced coils buckets & how you do the driver side hump? allso how wide does the coil buckets need to be from frame rail to frame rail after the coils are spaced?

Looking at doing a 2.3 in my 97, biggest problem is a 4x4 trans is about like unicon farts around here, had a few people tell me a 2.9 trans will bolt up? I would think I will have to change the bellhouseing, but what about clutch and thro out bearing? thnks in advance.

got a 97 4.0 auto with i assume, a 4r55e, got a 94 4.0 parts truck, will the 94 trans interchange with the 97?