Recent content by GrandpaSquid

I have not checked that but that would be too funny.

You are correct, that was an error on my part when writing this up. Those four wires are wired up using the adapter pigtail. I unplugged the brake light switch to test. With switch unplugged the radio does not turn on, but the cruise ON switch still does. Also checked the around the pedal arm...

The only thre wires used on my radio are power, ground, amd remote. It's the cheapest dual from Walmart. The rca outs go to the amps. And speaker wire is run from the 4 channel amp to the adapter pigtail. And this is a recent issue, stereo has be installed for a couple months with no issue. *...

Key out of ignition in the off position. No power to windows or radio(pressing the power button), but as soon as the brake light switch is engaged(brake lights on) the radio powers up as if the key is on(run position). None of the factory wires have been cut, all factory connectors are intact...

The other day I noticed that with no key in the ignition pressing the brake pedal cut the radio on. Truck is 93 Ranger 4.0 Auto. I used all the factory wires when installing the upgraded sound system. I used one of those plug and play wiring adaptors for the head unit, as well as premade...

Installed a warn trans4mer grille guard and winch plate. https://www.therangerstation.com/forums/index.php?media/albums/1993-ranger-4x4-stx.36/

I upgraded my sound system pretty goood. One amp runs the two 8" subs while the other powers the cabin speakers. Still need a head unit upgrade to get the full use of the 4 channel amp, but its way better than the stock. There is an album on my page with the photos of the install.

stuffs