-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Recent content by chadsworth2
-
Dana 28 to 35 swap Drive shaft length question
As stated by Jim in the tech articles, when swapping a Dana 28 TTb for a Dana 35 TTb, one must shorten the drive shaft by 1 to 1.5 inches. Is it possible to use the Drive shaft from the Dana 35 doner vehicle instead of shortening the Dana 28 vehicle drive shaft? Is the Dana 35 vehicle drive...- chadsworth2
- Thread
- Replies: 1
- Forum: Axles Forum
-
Dana 28 Front 23 spline Axle. Where do I get 4.10 gears at?
Does anyone know where to source 4.10 gears for the Dana 28 front TTB axle?- chadsworth2
- Thread
- Replies: 2
- Forum: Axles Forum
-
Limits of the Stock Electrical system?
Hello, Im new to this forum and the answere to this series of questions may already be out there. if so just link me to it! So Ive recently purchased an older 87 ranger that was pretty rough. Its come a long ways so far but now im getting into some modifications that are potentially putting a...- chadsworth2
- Thread
- Replies: 4
- Forum: Interior And Exterior Lighting