Recent content by c0ld

Im planning on buy this speaker (10 in. 2 ohm): http://www.jcwhitney.com and this amp: http://www.crutchfield.com/S-94Dd8uXnmGT/p_206ZX4001/Kicker-ZX400-1.html I want to try and make a custom box to go where the jump seat on the drivers side. Do you think the speaker could handle that amp? I'm...

I have an '89 ranger extended cab 4x4 with an explorer 8.8 and explorer springs in the rear. I took out the stock lift blocks and i have the stiffer springs, but I'm still having issues with the axle hopping in the sand when i step on the gas or when just starting out. I've been thinking about...

My dad's rain gutters on his ranger were rusting pretty bad so he decided to cut them off before it got any worse. This is what it looked like when he was done. He also painted his dash and s half way through putting it all back in.

My dad has an 87 ranger extended cab 4wd and the front sway bar bushings need replaced. His sway bar connects to the radius arms then go around the back of the axle and down the middle of the radius arm cross member. All I can find are bushing kits for the type of bar that goes around the front...

I was playing around in the backyeard yesterday and decided to take a couple pics. I bottomed out on this mound before i realized there was nobody here to pull it back off. Its an 89 2.9l 5 speed with a 3 inch body lift, explorer leafs and coils 31x10.50 wild countrys and an 8.8 swap with...