Update: I got new converters on today along with 2 new O2 sensors. Seems like it has a little more pep, who knows. Time to start checking MPG's. :icon_thumby:
I called the dealer and asked if it was safe to drive like this, and he said you won't have any problems with debris getting back into the engine. Somehow I don't believe him, especially now that the truck is out of warranty. Part seems to be coming in on a slow boat from China.
Today I heard a loud rattle when when i started the engine. It sounded like a heat shield rattling. I climb under the truck and heat shield welds are nice and tight. Started engine and the rattle was coming from the inside the first converter. Part still on order.
I know one thing, I will never buy a domestic branded vehicle again. Half of them are made in Mexico anyway. I've owned Honda's, Toyota's, and Hyundai's and never had this problem with a warranty claim.
I took truck to the dealer today and mechanic said converters were bad. Ford tried to deny a warranty claim 2 different times, and wanted me to pay $2400 to replace them. I fought with them and said I would contact the EPA. I showed them the warranty book that came with the truck that showed it...
I have a 2010 Ranger 2.3L, with 69,500 miles. I was driving down the highway and the CEL light came on, so I got off the highway and pulled into the nearest Autozone to have checked. The guy said it's a P0420 code that the catalytic converter was plugged. Is there a way of confirming this...
Update:
I removed Jet Performance Module and problem went away, no more stalling. I sent module back to Jet to be tested for a problem and got it back with a note saying "no problem found". I called to get the details and tech support said they checked everything out to see if printed circuit...
I took my truck into local repair shop to have things checked out. The mechanic checked everything out including checked for vacuum leaks and said everything checked out ok. He said to take it to the dealer and have Ford TSB 10-12-9 done to reprogram the PCM. I'm going to make an appointment to...
After replacing the IAC valve with a B/W unit in 4/16 the truck seems to doing the same thing now. The rpm's are fluctuating at a stop light, sometimes stalling. This is an intermittent problem. The truck has 64K on it now. Is there anything else it could be? :icon_confused:
Thanks.
I installed the Gibson stainless steel exhaust (p/n 619713) on my Ranger. I was very pleased that it was not loud. It was slightly louder than stock. The fit was excellent too. The folks at Realtruck.com were excellent to deal with too. They direct shipped it from Gibson in CA. I did have to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.