i think i read this before but i have replaced with all new from tank up both pumps reg and tank,have checked from relay back appears the frame pump has failed on this project tired of both pumps it is a 88 2.9 is there a pump that fits in tank that will provides enough pressure to run engine...
other than either motor or transmission pull what kind of job is it to remove and replace the seal? It looks different than most i have replaced?Any helpful hints or suggestions???
where can i buy the stub or a stub or axle bought the truck spindle bearing wore out the race anybody have know or can give part number it is a dana 28
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.